An EMF meter is an instrument that reads the fluctuation in electromagnetic fields. You should always take EMF readings at various places throughout your investigation. The locations of power lines, appliances and other sources of electromagnetic fields are also taken into consideration. Most normal readings are in the range of 9.0 - 30.0 on the EMF meter. These are typical EMF readings in a home. Anything that registers in the 2.0 to the 7.0 ranges and cannot be traced to a source is in theory to be paranormal activity. An example of a source would be a computer. The closer you get to a natural source the higher the reading. A natural source should always appear in the same place and will not disappear. Those readings can be thrown out.
When you get a short EMF reading in the 2.0 – 7.0 range which you do not get again in the same location and you do not find a natural EMF source then you have a positive EMF reading. It is scientifically impossible for low level and moving electromagnetic fields to occur naturally, and alot of times we find these odd readings in areas where there is paranormal activity reported. It is in thoery that ghosts and the energy associated with them are the causes of these unexplainable EMF readings.
These are the types we use:
This is a digital EMF detector. I like this because of its ease to use and accuracy. This meter is sensative when tilted or moved too quickly so proper technique must be used in order to get an accurate reading. Downside is it doesnt have light so we mounted a led book light on ours.
Here is the K2. This is extremely easy to use but i dont think extremely accurate. It is nice to have the bright lights in case you want to leave it with a camera on it to detect major changes in an empty room. Alot of groups use this item as a communication device by asking an entity to light up the device on command. I personaly dont believe it to be useful in that department and have never witnessed a K2 to be capable of that. If you buy one make sure it has a button that locks or has a toggle switch so you dont have to jam a coin in the button.
This is the Mel-8704R. We are still experimenting with this item. It has a vibration mode that is insanely sensative. The tri-pod you can purchase with it is a must. It can detect the slightest vibration from 20 feet away or more. It can also measure EMF and temp. at the same time which is a first. The Mel has EMF burst mode, data logging ,and many other features as well.
This is the Tri-field Meter. This meter is the only one which combines magnetic, electric, and radio/microwave detectors in one package, so that the entire nonionizing electromagnetic spectrum is covered. To make a long story short it is horribly accurate and can correct itself if off tilt. Best for the money in my opinion.
No comments:
Post a Comment